Thanks very much for Jitsi, it’s a great app
I’ve red some of the tutorial webpages in order to install my ownserver with the quick install and there is one thing that I’m still not sure about : Should I open
10000/udp, or the port range 10000-20000/udp ?
Thanks a lot,
We opened just 10000/udp at our videobridge installations and it is working fine.
Also based on damencho’s recommendation in this thread:
Port 10000 udp is where clients communicate with jvb, if you don’t allow this and haven’t done the port forwarding the clients cannot send to jvb and so nothing will be received.
You are scanning the wrong thing, you need to find one of the jvb instances which is used in your geo region and scan that
meet.jit.si is complex and not just a single machine and ip-address most probably you are scanning just one of the load balancers fronting the service …
You need to open/forward nee…
I have only 10000/udp open, not range as I saw on wiki.
But I haven’t tested multiple conferences at same time on same Videobridge.