[jitsi-users] Jitsi-videobridge + Prosody

Hi again,

I am trying to run Jitsi meet on a windows server.

Following instructions here:
https://github.com/jitsi/jitsi-meet/blob/master/doc/manual-install.md

I installed and configured all the the following components:
Prosody, nginx, Jitsi-videobridge and Jicofo.

all 4 components seem to be running ok together for the most part

except when I ran Jicofo i got a warning in Prosody:

Client is violating RFC3920 (section 6.1, point 7).

but client was connected and authenticated.

and got this warning in jicofo console:
2015-06-29 13:16:21.110 WARNING: [16]
org.jitsi.jicofo.BridgeSelector.addJvbAddr
ess().170 No pub-sub node mapped for jitsi-videobridge.jitsi.mydomain.com
statis
tics will not be tracked for this instance.

I'm a bit stuck with the last step:
Deploy Jitsi meet...
After checking out the source how do I proceed on windows?

Thank you

You should configure nginx to server it. It should be pretty similar to the description we have, but probably not exactly the same.

Regards,
Boris

ยทยทยท

On 29/07/15 08:57, bpath developer wrote:

Hi again,

I am trying to run Jitsi meet on a windows server.

Following instructions here:
https://github.com/jitsi/jitsi-meet/blob/master/doc/manual-install.md

I installed and configured all the the following components:
Prosody, nginx, Jitsi-videobridge and Jicofo.

all 4 components seem to be running ok together for the most part

except when I ran Jicofo i got a warning in Prosody:

Client is violating RFC3920 (section 6.1, point 7).

but client was connected and authenticated.

and got this warning in jicofo console:
2015-06-29 13:16:21.110 WARNING: [16]
org.jitsi.jicofo.BridgeSelector.addJvbAddr
ess().170 No pub-sub node mapped for
jitsi-videobridge.jitsi.mydomain.com
<http://jitsi-videobridge.jitsi.mydomain.com> statis
tics will not be tracked for this instance.

I'm a bit stuck with the last step:
Deploy Jitsi meet...
After checking out the source how do I proceed on windows?